Auto Set is a breakthrough control that automatically sets your welder to the proper parameters
Offers all-in-one MIG, minus the guesswork
Smooth-Start patent-pending technology provides a smooth, spatterfree start
It’s the best-starting machine in the small MIG machine category
No pop gun starts and no spatter to clean up
Infinite Voltage Control with Manual On/Off Wire Feed Speed Tracking provides a broader operating range with finer control by automatically increasing or decreasing wire feed speed when voltage is adjusted (unit shipped with wire feed speed tracking set to “off”)
Semiautomatic constant voltage wire welding package is capable of welding 24 gauge up to 3/16" (0.8 – 4.8 mm) mild steel
Durable cast aluminum feedhead incorporates dual-groove quick-change drive roll and spring-loaded tension arm with calibrated tension knob all designed to make set up easier and faster
Miller’s exclusive “Tip Saver” short circuit protection shuts down output when tip is shorted to the work
Extends contact tip life and protects internal components from damage
Trigger reset permits quick reset at torch rather than unit
Easy access to output studs provides convenient polarity changeover when changing from solid or flux cored wires
Thermal overload protection shuts down unit and activates over temperature light if airflow is blocked or duty cycle is exceeded
Automatically resets when fault is corrected and unit cools
Standard built-in solid-state contactor circuit makes wire electrically “cold” until trigger is pulled, making the unit safer
Easier to position torch to work before starting weld
Self-resetting motor protection circuit eliminates the need to find and replace fusesInput Power Requires 1-Phase Power, 115 V, 20 Amps 60 Hz
90 A at 18 VDC, 20% Duty Cycle Rated Output
30 - 140 Amps Output Power RangePower source
6' (1.8 m) power cord and plug
10' (3 m), M-10 MIG gun and cable assembly
10' (3 m) work cable and clamp
Smith Argon and AR/CO2 mix regulator/flow gauge with hose
Spool of Hobart .024" (0.6 mm) solid wire
Two contact tips for .024" (0.6 mm) wire and two contact tips for .030" (0.8 mm) wire
Dual groove quick-change drive roll for .024" (0.6 mm) or .030/.035" (0.8/0.9 mm) wire
Factory-installed gas solenoid valve
Set-up and operation video
Information/settings chart
Material thickness gaugeReplaces 907019
